 |
Mould quotation and quotation, quotation and mould price |
| After the valuation of the mold, and can not directly as a quote. In general, but also according to market conditions, customer psychology, competitors, the state and other factors for a comprehensive analysis of the estimated appropriate finishing, in the valuation of the basis of the increase in 10-30% put forward the first quote. After bargaining, according to the actual situation to reduce the offer. However, when the mold to discuss the quotation is lower than the valuation of 10%, the need to re refine the mold to refine the estimate, in the guarantee of favorable conditions, the signing of a processing contract, and finally determine the mold processing prices. The mould price is the price that has been approved and signed by both parties. At this time the formation of the price of the mold, there may be higher than the valuation or lower valuation. |
 |
Regional difference of mould price and time difference |
| It should also be noted that the valuation of the mold and the price, in various enterprises, various regions, countries; in different environments, the connotation is different, there is a regional difference and time difference. Why the price difference, this is because: on the one hand mold conditions of different enterprises, different regions, countries are not the same, all aspects of the process equipment and technology, the personnel, the consumption level of different, different estimates produced by the mold cost and profit objectives, resulting in a poor price of different mold. |
 |
Mold quotation sheet |
| Mold price estimates, the general need to quote in the form of outward quotations. Quote the main contents are: Mold Quotation, cycle, required to achieve the mold (life), the technical requirements of the mold and conditions, payment and settlement methods, as well as the warranty period, etc.. |
 |
General categories of plastic mold |
| Two plate mold, also known as single type mask, is a kind of the simplest of injection mold, it to the sub surface interface will the mold is divided into two parts: moves the mold and the fixed mold. Part of the cavity in the dynamic model, the other part of the cavity in the fixed mode. Sprue on the fixed mould; shunt opened on the parting surface, mold, products and channels in the moving die, moving mould part is provided with a top out of the system. |
 |
Plastic mold forming classification |
| Is first the plastics are added to the injection machine of the heating cylinder, the plastic is heated and melted, under the impetus of the injection machine screw or plunger, into the mold cavity by the nozzle and the mold gating system, due to the physical and chemical effects and hardening shaping become an injection molding products. Injection molding consists of injection, holding pressure (cooling) and plastic parts ejection process of cycle cycle, so the injection molding has the characteristics of periodicity. The injection molding of thermoplastic plastic injection molding has short cycle and high production efficiency, and the wear of the mould is small, and the shape of the mould can be formed in large scale. |
|
